Glue-in pot magnets

Glue-in pot magnets These neodymium pot magnets are glued into indentations when screwing is not possible. They have a higher adhesive force than countersunk pot magnets of the same size because the contact surface is larger. Please note: The magnets are not self-adhesive; a suitable adhesive is linked under accessories.

Filter for size and adhesive force
Reset filter
Diameter
-   mm
Strength
-   kg
Pot magnets glue-in
FGN-10
Glue-in pot magnet, Ø 10 mm, Strength approx. 2,2 kg

FGN-13
Glue-in pot magnet, Ø 13 mm, Strength approx. 3,2 kg

FGN-16
Glue-in pot magnet, Ø 16 mm, Strength approx. 5,5 kg

FGN-20
Glue-in pot magnet, Ø 20 mm, Strength approx. 9 kg

FGN-25
Glue-in pot magnet, Ø 25 mm, Strength approx. 22 kg

FGN-32
Glue-in pot magnet, Ø 32 mm, Strength approx. 34 kg

FGN-42
Glue-in pot magnet, Ø 42 mm, Strength approx. 68 kg

FGN-48
Glue-in pot magnet, Ø 48 mm, Strength approx. 85 kg

FGN-60
Glue-in pot magnet, Ø 60 mm, Strength approx. 130 kg

Features of pot magnets

Principle: The strong neodymium magnets are embedded in a steel pot. The steel pot increases the adhesive force of the magnet on direct contact with a thick iron surface. If there is no direct contact with the counterpart, or if the steel plate is thin, painted or rough, you can strain it much less.

Shear force: The indicated adhesive force was measured perpendicular to the surface to which the magnet should stick. It takes a lot less strength to move the magnet sideways. Therefore, you can strain a pot magnet much less if you use it on a wall as opposed to using it on the ceiling.

Rust: These magnets are not rust-proof and therefore intended for dry indoor use.

All further information regarding these products can be found in our FAQ about pot magnets.

The following products may interest you as well:

Countersunk pot magnets

Self-adhesive magnets

Screw-on counterparts for magnets