Frame for a wooden puzzle
Do a puzzle - frame it - turn it - and do a puzzle again
Online since: 05/02/2008,
Number of visits: 372105
0
Here's another prank from Stéphane in France, who likes both puzzles and our magnets:
On the edges of the glass and the wood, I glued 8 magnets with UHU MAX REPAIR
and placed the pieces in an oven heated to 80° C for 40 minutes to dry.
The height of the two magnets S-05-02-N52N
corresponds to the thickness of the puzzle to ensure a good hold.
When the frame was finished, it remained only to hang the picture.
Fortunately I have metal door frames in my flat so I could use two S-20-10-N-Magnets
(very strong!).
One was glued to the back fo the frame, the other could be placed without glue on the metal door frame.
So that it wouldn't slide to the floor, I placed a bit of double-sided tape at the right height.
This would allow me to move the puzzle to another place without any trouble, if only these magnets weren't so strong and therefore difficult to remove from the door frame! ;-) With a small bit of cardboard glued on the top of one magnets, you can protect the frame from crashing too hard into the door magnet.
The entire content of this site is protected by copyright.
Copying the content or using it elsewhere is not permitted without explicit approval.
Copying the content or using it elsewhere is not permitted without explicit approval.